Gaz silindirinin samanını pürüzsüz bir ereksiyon için bezin içine sokmak.
13,242 81%
,jpeg/023/823/227/1280x720.c.jpg.v1695833005)
With the oxygen gas cylinder I implanted the straw in the glade and then there were many extreme cumshots.
7 ay önce
,jpeg/024/568/810/1280x720.17139353.jpg)
,jpeg/024/370/870/1280x720.17092780.jpg)
,jpeg/014/988/770/1280x720.3.jpg)
,jpeg/019/057/815/1280x720.3.jpg)
,jpeg/023/929/572/1280x720.c.jpg.v1698283044)
,jpeg/024/233/133/1280x720.17058765.jpg)
,jpeg/024/016/289/1280x720.c.jpg.v1700347095)
,jpeg/019/075/039/1280x720.3.jpg)
,jpeg/010/030/309/1280x720.9.jpg)
,jpeg/016/101/243/1280x720.1.jpg)
,jpeg/013/256/006/1280x720.5.jpg)
Yorumlar
3
Yayyy!!! You tried! Thank you. Melt the end with a lighter slightly to round off the sharp edge of that plastic. Also, you may want to cut the last 1/4" off the end first because I think the second graduation up will fit you just fine, perfectly in fact. That first stem is too long for now. Just be sure to melt the edges slightly with a lighter, rounding the edges off while it's still maliable with your fingers. Let it cool then send it in a little slowly going about half an inch. Tape it there if you need, which will free that hand to use elsewhere. Good job bro. Hot to finally see this . I knew you could do it. HOTAF